Woody Runabout phase 16

One of several mistakes made during construction (yet to be rectified) was the inadvertent use of a waxy sanding sealer on the side panels. The adhesion is poor and I shall probably have to re varnish. The lesson: ALWAYS READ THE LABEL. I  discovered the error when using gaffa tape to hold a few slivers of wood where the frames meet the gunnels. On removal of the tape a patch of bare wood was revealed minus the varnish!   I intend leaving the job until autumn.  The wax base will need to be removed with a solvent and vigorous sanding.

The floor  is laid and incorporates sealed flotation chambers between the frames, now being painted before completion of the decking, fore-deck and transom decking.  The outboard unavailable till June because of the Covid-19 epidemic, as is the interruption to wood supplies which threatens to slow up progress.

In advance of decking, there have been fixing points for cleats added, and also fixing points for screw down straps that will secure the fuel tank and battery. Remote controls for the outboard run either side down the gunnels, and I am pondering the idea of inserting some PvC pipework to contain it, so as to make insertion and removal simpler to do. Putting such ideas down helps in the decision making and yes, I think I need ponder no more, just do it!

Unexpected problems always arise in scratch built projects such as this, and solving them becomes part of the enjoyment of brain teasing, burning of the midnight oil. One of them is how best to arrange the seating. Two seats, three or four, and should the rear one(s) face forward, sideways or rearwards, The best solution I am presently considering is to have the rear pair of seats facing inwards, facing each other so that weight would then be into the centre and away from the stern. So far, only one of the seat backs has been fabricated, in the form of an an ellipsoid hoop that I intend to make fold forwards. Laced with supportive Dyneema paracord. Sounds like one of granddad's lash up bodges, or it might just be some artistic licence and definitely unique. 

WoodyRunabout Phase 11

3rd April sees me preparing the underside for painting an Ivory colour and ready to veneer the side panels with Mahogany, prior to laying on Epiphanes varnish.
The gunnels are fitted ,but will require additional layers once the woodshop re-opens.
The gunnels are glued and pegged with bamboo pins, avoiding screws in all but high stress areas, such as the prow and transom. I shall use screws for fixing the thwarts and dashboard because these need to be removable. 

Transom marked for the  cutout in way of the outboard motor.

Bottom panels prepared with Pre-Coat white base

Gunnels glued and pegged in position

Spray rails and keel ready for the plastic keel bands